Files
CoCo3_Plus_MiSTer/verilator/rtl/VDAC.v
Alan SterembergandClaude Opus 5.5 874f4f3083 Add Verilator simulation (ImGui + headless)
verilator/ runs the core on the host with the shared FM-7 / Apple-IIgs sim
framework: windowed (ImGui/SDL2) or --headless, typing on a frame schedule,
screenshots, text-screen dump, 6809 disassembly trace, floppy/SDC/cart/cassette,
and RS-232 Pak serial debugging (TXD decoder, RXD driver, pty bridge, ACIA
trace) with a minimal DriveWire server and a script to run the real FujiNet
daemon against the sim. See verilator/README.md.

- The VHDL the build uses (ROMs, RAMs, font) is converted to Verilog in
  verilator/rtl/; the VHDL CPU is not instantiated (CoCo3_CYC_ACC_6809).
- sdram2.sv is simulated with its own controller logic and an SDR chip model.
- run_tests.sh: boot, keyboard, disk, WIDTH 80 and HSCREEN tests, judged on
  the text screen and byte-for-byte against test-ref/ screenshots.

rtl/wd1793.sv: spt_addr and buff_wr are declared at module scope instead of
inside generate blocks. They are assigned outside those blocks; Quartus
accepted it, Verilator rejected spt_addr and silently split buff_wr into a
separate net. No change on the FPGA (FM-7 made the same fix).

Co-Authored-By: Claude Opus 5.5 (1M context) <[email protected]>
2026-10-02 07:15:44 -04:00

28 lines
957 B
Verilog

//============================================================================
// Simulation stand-in for rtl/VDAC.v (an altsyncram megafunction).
//
// Same ports and the configuration the megafunction declares: DUAL_PORT,
// 256 x 16, write on wrclock, address AND output registered on rdclock
// (address_reg_b = outdata_reg_b = CLOCK1), so q lags rdaddress by two
// rdclock edges. Preloaded from rtl/VDAC.mif via verilator/rtl/vdac.mem.
//============================================================================
module VDAC
(
input [15:0] data,
input [7:0] rdaddress,
input rdclock,
input [7:0] wraddress,
input wrclock,
input wren,
output reg [15:0] q
);
reg [15:0] mem [0:255];
reg [7:0] rd_a;
initial $readmemh("rtl/vdac.mem", mem);
always @(posedge wrclock) if (wren) mem[wraddress] <= data;
always @(posedge rdclock) begin
rd_a <= rdaddress;
q <= mem[rd_a];
end
endmodule